1111 Pneumatic Cylinder
TYPE A Double-Acting
Linear Ball Slide
Cylinder bore diameter 10/16/20/25/32/40 mm
Ball bearings, that run on linear hardened and ground steel tracks, are retained in a linear cage This makes it possible to stress the unit in all three axes. This model is being phased out, but is still available as replacement.
|
1211 Pneumatic Cylinder
TYPE B Double-Acting
Linear Ball Slide
Cylinder bore diameter 8/10/16/20/25/32/40 mm
Similar to Type A, Type B is built with hardened and ground steel guide rails that permit greater loads. It is also available with dust-proof protection.
|
1221 Pneumatic Cylinder
TYPE B Twin Double-Acting
Linear Ball Slide
Cylinder bore diameter 20/25/32/40 mm
This type B Ball guide/slide/actuator includes 2 air cylinders, both double acting. The double cylinders produce double force and greater load capacity in this low profile configuration. A dust-proof version is also available.
|
1311 Pneumatic Cylinder
TYPE C Double-Acting
Linear Ball Slide
Cylinder bore diameter 10/16/20/25/32/40 mm
The guides On type "C" are made of hardened and ground steel rods. The balls run in continuous ways integrated in the base body. This allows the slide to be stopped at any position in either direction without jamming. These ball slides are equipped with integrated sensor grooves for electrical/electronic limit switches. The cylinders can be supplied with end position cushioning with external and adjustable limit stops or small hydraulic shock-absorbers (see accessories).
|